HP ProLiant MicroServer Screw Location

After unpacking my ProLiant MicroServer (it will replace Atomtux as the Atom 330 just isn’t cutting it anymore speed wise), I was expecting to see a packet of screws for the hard drive bays (has a 4x cold swappable 3.5″ SATA HDD bays). Alas, there was no packet. After a little searching, I found the screws, along with a wrench for them. They are attached to the door covering the hard drive caddies.

There are 16 screws attached to the door for hard drives, and 4 for an optical drive (to be placed in the 5.25″ bay). Yes, there are 4 extra hard drive screws (one bay comes populated with a 250GB Seagate hard drive).

-John Havlik

[end of transmission, stay tuned]

3 thoughts on “HP ProLiant MicroServer Screw Location

    • Honestly, I’ve had it since March (I think) and have just gotten Funtoo on it. Hopefully, I’ll swap it in for Atomtux in a week or two. It is much faster than an Atom 330, that’s for sure (the 4X more memory helps too).

      -John Havlik

Leave a Reply

Your email address will not be published. Required fields are marked *